The Impedance Calculator performs two way calculations between the following parameters: line width, differential line width & spacing, substrate thickness, impedance, and dielectric constant for various micro-strip and stripline configurations.
The only impedance calculator that will allow for trace etch taper and a separate dielectric constant for solder mask. The only impedance calculator that will quickly fine tune trace and substrate structures with geometry calculations based on input target impedances.
Impedance Calculator is available as Stand-Alone software for use directly Inside Microsoft Windows™
Key Features:
Easy to use
Graphical User Interface
Built in Material
libraries
2 way calculations
with automatic iterations for
complex calculations
Microstrip,
Stripline Single or Differential
Pair, and mixed-dielectric
differential stripline calculations
Slides illustrate
the cross section of each
configuration
Unitless
Calculations are accurate up to a maximum 2GHz frequency
Various Impedance Calculations:
Microstrip with or without soldermask
Independent dielectric constant for soldermask
Microstrip and stripline rectangular or trapezoidal trace configurations
Differential and common mode impedances calculated for differential pair routing
Mixed-Dielectric Stripline configuration for accurate calculation of composite substrates.
Propagation delay calculations, Geometry Calculations,
Differential width and spacing can be calculated from the desired impedance through iterations
Accuracy correlation to within 1.0 percent of high-end field solvers on the market today!
Note box for user reference information
Print button to print out current dialog box with settings.
Impedance Calculator performs two-way calculations for various Differential Microstrip and Stripline configurations between the following parameters:
-
Line width
-
Differential line width & spacing
-
Substrate thickness
-
Impedance, and dielectric constant
